Sequencer
Sequencer
[SHIFT] + [>] or [<]
[SEQ] + [>]
[SEQ] + [<]
[SEQ] + [PAD]
[TRACK SEL] + [PAD]
[SEQ], [SHIFT] + [PAD], [C1] to [C4]
In Step Edit, press [PAD] again
In Step Edit, hold [SOUND] or [FILTER] or [MOD] or [FX] + [VALUE]
[PAD] with source Step, [SHIFT] + [FX], [PAD] with destination Step, [SHIFT] + [FX]
[SEQ], [SHIFT] + [PAD] with Step, [SHIFT] + [FILTER], rotate [VALUE] to shift Note Up, Down, Right, Left or Quantize
[SHIFT] + [PROJECT] + [PAD]
[PAD] of Drum Part and then [SHIFT] + [PROJECT]
[PLAY], [RECORD], hold [SHIFT] + [PROJECT]
[SHIFT] + [PROJECT] + [SEQ]
[SHIFT] + [SEQ], [SHIFT] + [PAD] for First Step. Or [PAD] for Last Step
[SHIFT] + [SEQ], [SHIFT] + [PROJECT]
[NOTE], [SHIFT] + [PAD]
[SHIFT] + [NOTE], rotate [VALUE] to find "SCALE"
Hold [NOTE] + [OCT-] or [OCT+]
[NOTE] in Note Mode of a Tone Track
In Chord Mode, [SHIFT] + [FILTER]
[SOUND]
[EXIT] + [<] Notes: Switching between Tracks or Clips will erase the Undo content; Undo and Redo will not work while recording; Undo will allow up to 10 steps
[NOTE], [PAD] to select Drum Part, [SEQ] to enter Steps. Select Drum Parts with [VALUE]. To enter a Tie, [PAD] with Step + [EXIT]
[SEQ], [PAD] for First Step, [NOTE], [PAD] for First Note or REST/TIE [PAD] to add silent Steps or select next Steps with [VALUE]. Add Notes with [PAD] or create Ties by holding [PAD] with Note and pressing REST/TIE [PAD]
[SEQ], [RECORD] + [PAD] with First Step, [NOTE], [PAD] for First Note, then the following Notes or REST/TIE [PAD] for Tie
Create more than one Clip with more than 128 Steps and Chain them in Clip Settings, then Record the Sequence or Motion
In Step Edit, hold [FX], rotate [VALUE]
With the default Clip Scale of 1/16, a Note Length of 3.99 will last for 1 Beat. If the Clip Scale is set to 1/32, then a Note Length of 1.99 will be 1 Beat. If the Clip Scale is set to 1/8, then a Note Length of 7.99 will be 1 Beat
Create a new Drum Track and load a Sample with an instrument to each [PAD]. Create different Notes for this instrument with "PAD EDIT" and changing "KEY OFFSET" to match the desired Note for each [PAD]. Record a Sequence, press [SEQ] and [SHIFT] + [PAD] on a specific Step. Lastly, change "MTE" to the desired Mute Probability for that Step
Press [Note] while in Scale Mode to temporarily go back to the chromatic keyboard. Press [Note] again to go back to Scale Mode. Rest works for both single notes and chords, but in firmware version 1.82, Tie only works with chords
To prevent overlapping notes at the beginning of a Clip, when recording an arpeggio, go to Clip Setting and select "NEXT CLIP: STOP". This will ensure the Clip stops after looping and the Arpeggiator notes will not overlap with the previously recorded notes. You will need to change that setting after recording, if you wish the Clip to loop or to move to a different Clip